3/17/2024 0 Comments Motionpro 650 classic clutch cable![]() ![]() As to adjustment, I adjusted mine to hit the friction zone at approximately 1.5" of pull at the lever. I would have to say that cleaning once to twice a season and use of a quality chain lube or cable lube should minimize any wear. This arrangement leaves enough exposed cable for the clutch arm to move fully and protects 75% of the cable from any wear. One end is fit over the end of the adjuster on the end of the cable sleeve. the cable is highly visible in the spring now and can easily be inspected for signs of wear. The spring will still touch the cable on compression of the spring but the friction is so light that I believe the cable rubs much harder inside its jacket than it dose at these points. I tested the lever movement and found, two to three wraps of The smallest diameter shrink tube that would fit on could not shrink enough to stay in place. Could not use shrink tubing due to diameter of cable end. The spring used is 5" uncompressed, cable guard is 1/4" split loom wire cover. It keeps the end knob tight in the shifter linkage and allows you toadjust 1.5" more slack at the grip, without ending up with the lever floppingaround. I just had a brain storm one night, and went out and added this spring tothe clutch cable. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |